You are looking at a spotless 2012 Corvette Grand Sport that has a full professional build to over 1000 HP! This car started as a perfect 1lt equipped M6 Grand Sport finished in Velocity Yellow over Black leather with only 2k miles almost 2 years ago. The car went to Slow Motion Motorsports in Sunbury Ohio where no expense was spared to build the perfect street car set up that maintained daily drivability with the power to outperform at the drag strip! This car has been down the quarter mile one time with a VERY EASY launch it ran 11.0 at 140mph with a 2.3 60ft. If driven hard this car is MUCH faster than that.
The condition of the car is near flawless, there has never been any paintwork to the car ever, the interior shows no wear and is a non smokers car. The only modification to the inside is a 2 pillar gauge mount which holds a/f, fuel pressure and of course a boost gauge and aCO2 intercooler kitcontrol in the ashtray. All of the interior changes are very nicely installed. It does have a complete stereo upgrade with navigation head unit, back up camera and upgraded speakers throughout in OEM locations.
The only damage to note is on the front right bumper cover under the fog light, I hit a possum and itcracked the bumper about 3". I chose not to paint the bumper because it was not that noticeable.
The outside was just professionally detailed with a paint correction process and shines better than new. It is equipped with the ZR1 carbon fiber front splitter, carbon fiber rear spoiler, the roof has been wrapped in Gloss Black Wrap and it has black Grand Sport emblems. The car appears completely stock from the outside except for the Weld wheels.
I have every receipt for the build as well as several pictures throughout so please call me directly with any questions. I will be happy to forward any information to serious buyers. This car is turn key with no stories.
Call Denny with questions-614-623-2753
Beloware the specs-
2012 Corvette Grand Sport 1lt
Vin 1G1YP2DW7C5106549
6 speed manual
6.0 iron block (Motor has 5,000 miles on it now)
Stock LS3 Forged Crank
Texas Speed super I-beams connecting rods with arp 2000 part #25-tsp6125-ib-8
Wiesco forged pistons set 4.005 bore,3.622 stroke,6.125 rod,flat-top with -3.2cc part #10-k398x05
Valve reliefs,includes wrist pins and gfx stainless top rings
aeromotive fuel pressure regulator, all e-85 custom fuel lines front to back
pfadt motor and transmission mounts
dewitts radiator part #1139125e
brand new front rotors and hawk pads (4000 miles on them)
amsoil dominator 10w30 oil only
innovative 3882 wideband
Weldon d2035-a fuel pump external
msd wires
holley black valve cover
2bar map sensor
2 pillar gauge pod
Weldon fuel pump controller
trick flow ls3 heads reworked from total engine airflow company
trickflow 7.700 pushrods
chevy performance ls3 lifters
Brian Tooley trunnion kit
fuel rail/line kit aer-14115
obx longtubes,x-pipe
ati balancer part #918620
ati pin kit
remote clutch bleeder
Full custom surge tank behind rear bumper -10 lines
fuel pressure gauge
brand new slave cylinder (8000 miles on it)
mgw shifter
Procharger F1-a with 8 rib,Race intercooler,and race bov
hobbs switch for fuel pump, comes on at 0.0 boost at 100%
New Master cylinder (8000 miles on it)
Heat shield sleeves for wires
Design Engineering cry02 sprayer kit ( Works at 0.0 boost)
Spec twin disk Part #sc66pt (Clutch has 8000 miles on it)
full kit hydraulic bearing,slave assembly
ngk tr6 plugs ( have 500 miles on them)
btr oil pan gasket
lpe 160 thermostat
17x4 weld s77b
15x10 weld s77b
mickeye Thompson et street r's in the back
Tuned for E-85 only
Heads were Re-Freshened 5000 miles ago with new e-85 seals,448lb valve springs and stainless steel valves.
LG Spindles with base C6 Brake Assembly in the rear for the 15's
B&B Fusion with mild to wild switch 2.5 inch
Car made exactly 900whp at 14psi 6400rpm