1970 Chevrolet C-10 Custom
This truck is FULLY Operational, starts up instantly, run and drives, is registered in California until November 2017
It is however an unfinished project at approximately 90% completion in my opinion and for my use. you may want to take it to the next level for your use. all parts I have will be included, including the original Bed/tailgate/rear bumper assembly.
Semi Frame off to check / clean / treat any rust spots, was not much to start with
Minor body rust here and there in the usual spots, rockers rusted through and were going to be repaired next. rust spots on bottom of both doors and center of driver door
14 bolt (1 ton) rear end , 373 gears
Transmission TR350 rebuilt all the good stuff, Hughes torque converter
Crate 383 Stroker ($7500), Weiand intake, HEI distributor, (see pictures) less than 1250 miles on engine
Dana 44 front axle, spicer locking hubs, 373 gears, needs ball joints replaced soon (new spicer ball joints, and hub seals included)
New Front disk brakes and rotors (was planning on redoing all plumbing for brakes and transmission, all is working fine just not routed as I would like)
new power steering pump and steering gear just installed (needs fine tuning).
NP205 Transfer case rebuilt and with dual stick option, front drive shaft included / not installed yet (was planning on purchasing dual stick after completion of interior)
New FullRiver FT825-34 Battery ($220).
New Dash Cluster.
New rear window and seal (includes all rubber for all windows and door seals (front window cracked and was to be replaced soon). replaced all rubber / widow track and inside hardware on drivers side, still need to do passenger side
would prefer local pick-up, but willing to ship with your help, or willing to do anything I can to assist with your shipping request.
1970 C10
click to enlarge
1970 C10
click to enlarge