Body and aero.
·Complete Z06 Body with factory carbon fiber fenders
·Carbon Fiber ZR1 skirts and splitter.
·Carbon Fiber rear spoiler
·Custom brake ducts using factory fog light locations
Suspension & Brakes
·LG Motorsports Front and Rear Sway Bars
·LG Motorsports Coil Overs
·Phadt Urethane suspension bushings
·Hinson Urethane motor & transmission mounts
·Z06 Calipers with Performance AFX rotors
·Carbo Tech XR2 race pads
·LG brake cooling ducts
·Corner Balanced
* Track Alignment
Safety Equipment
·Sparco Evo racing seats
·Team Tech 5 point Jet Pilot Harnesses with chest strap
·Custom roll cage hoop welded in with removable rear section and harness bar
Engine and Cooling
· ERL built 440 LS3 600+ HP, 550 torque all the right parts
·West Coat Cylinder Heads stage 3 LS9 heads
·Fast 102 Intake
·Vararam ram air
·Accusump
·Mezier racing water pump
·Ron Davis Radiator
·Z06 Oil Cooler
* Puke Tank
* LG Headers and Exhaust
Transmission and rear end
·Custom built hi performance 6 speed automatic.
·Circle D light weight torque converter with small stall (not noticeableon street)
·Custom programming of transmission to greatly increase shift speeds
·Dual 40,000 BTU transmission coolers at rear diffuser to keep trans temps below 180 at the track.
·RPM Transmissions hi performance stage 3 rear diff with Quaife and 3.15 gears.
Interior
·Custom yellow center console with matching gauge pods
* Z06 InstrumentCluster
Other Mods
New Drive Shaft
New master cylinder
New brake booster
Sound Deadening kit
Cover shown in pic
New Windshield
The engine has less than 5,000 miles on it and the transmission has less than 1,000 miles. The new suspension has about 10,000 miles on it.3LZ means Heads up display, heated seats (have original), power seats both sides, automatic climate control, memory seats and wheel, GPS and all the luxury goodies.ERL Performance 440 LS3 was $15,000, transmission was $5,000, Suspension was about $4,000, Brake rotors and race pads $2,000, upgrading cooling systems $2,500, Programing and Dyno work $3,500, Body $5,000, Paint $8,000, Carbon Fiberaero parts $2,000, Custom Roll bar$4,000. I could go on but you get the idea. At one point I added it up and it was more than $50K in all the mods. This includes programming of computers, chassis set up and getting it all dialed in for the track. It currently has R6 Slicks on it.