1967 Camaro LS1 Resto-mod

1967 Chevrolet Camaro Description

Here is your chance to own a piece of American history as the Camaro celebrates 50 years. Up for auction is a 1967 Chevy Camaro Resto-Mod work in progress. It is a first generation Camaro built at the Norwood, Ohio plant. I began the bodywork on this restorationon a rotisserie. The following has been done to date:

• LS1 Motor & Trani (with a clean VIN #) out of a 2000 TransAm with 90k miles on it
• New Painless Wire Harness
• New Front/ Rear Disc Brakes / Stainless Steel Lines / Booster
• New Exhaust / Flowmaster
• New shocks
• Sub frame powder coated
• New Springs Front & Rear
• New Spring Bushings and shackles
• New Energy Suspension Body Bushings
• New Energy Suspension Control Arm Bushings & Hardware
• New Inner / Outer Tie-Rod ends / Idler Arm by Moog
• Original Rebuilt Steering Box
• New Moog Ball joints upper/lower
• New U-Joint
• Drive shaft cut & balanced
• New Lokar Gas Pedal / Excelerator cable
• New Lokar Shifter
• New Cooper Tires
• New Hood Latch
• New Emergency Brake Cable System
• New Water Pump
• New Thermostat
• New Tensioners
• New Power Steering Pulley
• New Battery
• New Plugs &Wires
• New Belt
• New Holley Oil Pan
• New Gas Tank from Rick's Tanks
• New Gas Tank Filter Assembly
• New Tail Shaft Seal
• New Trani pan Gasket & Filter
• New Radiator Support
• New Battery Tray
• New Mirrors
• New Front Window Molding / Clips (All pins in place to make molding install a breeze after paint)
• New Rear window to trunk lid panel with all new clips all around rear window (All pins in place to make molding installation a breeze after paint)

This is just a partial list. Please email me if you have specific questions. The car runs and drives great with no check engine light. Lights (High & Low Beams/ Brake), Horn, Turn Signals work. I have put a lot of time and effort intoher butshe needs someone to takeher to the final stages of completion. I am in a position that I must sell.
The following is a list of Original parts that were removed to do the bodywork and are included:

• Left and right door regulators & window
• Butterfly windows
• Rear glass / Regulators
• Chrome trim above passenger windows that holds the weatherstripping
• Speedometer Cluster
• Window/ Lock Handles
• Front bumper brackets & bumper

I am including all parts that I got when I purchased the car.
Buyer is responsible for all shipping arrangements & fees. $500 Non-Refundable Deposit Required within 24 hours of auction end thru PayPal. Final Balance to be paid within 7 days of auction end with certified bank check. Vehicle must be picked up within 10 days of auction end or seller reserves the right to return payment less $500 non-refundable deposit and relist.Please bid responsibly. A bid is a binding offer to purchase.If car is to be shipped, transporter must be available to pick up vehicle within 10 days of auction end so please be sure of this PRIOR to bidding.Full payment must be cleared prior to vehicle pick-up. Thank you in advance.