1968 CHEVY 3/4 TON PICKUP TRUCK 4x4 MUD PULLING TRUCK 67 68 69 70 71 72

  • Condition: Used
  • Make: Chevrolet
  • Model: C-10
  • Type: Standard Cab Pickup
  • Trim: C20 3/4 Ton 4x4 Long Box
  • Year: 1968
  • Mileage: 98,881
  • Engine size: Small Block Chevy
  • Number of cylinders: 8
  • Fuel: Gasoline
  • Transmission: Manual
  • Drive type: 4WD
  • Options: 4-Wheel Drive
  • Vehicle Title: Clear
  • Interested? Contact seller!

1968 Chevrolet C-10 Description

This is a 1968 Chevy 3/4 ton 4wd pickup. It is mainly complete but is going to need total restoration or use for parts. The drive train would make a great start to a mud or pulling truck. This truck was bought used by my dad when it was only a couple years old. I got it from him and drove it several years but it has been sitting for several years now. The odometer shows 98881. I'm pretty sure that is original.
It has a small block Chevy engine which I had running a couple years ago. It does turn over by hand. I'm going to see if I can get it started before the listing ends. At this point, you are buying it not running.
The body is rough but repairable. The bed of the box, rockers and cab corners are bad. The seat cushion is also bad but it probably could be redone.The windshield is cracked but the rest of the glass is good. The tires and brakes are bad.
This is being sold for parts or repair. Sold AS IS. I will answer any questions the best I can.

On Apr-07-16 at 19:04:36 PDT, seller added the following information:


UPDATE!!!!!
I did get the truck running today. I cleaned the points, put a external test condenser on it, installed a battery and put some gas in the carburetor. It rolled over a few times and it started right up. It ran pretty good. Good oil pressure.No smoke. I'm not sure about the condition of the internal parts but it does run.
It has a 4 speed manual transmission. Shifter is on the floor.
Again, it is not driveable. The battery and the test condenser does not go with the truck.