Hi all, I have to sell my baby. I have a ton of blood, sweat, tears, and money (just over $30k, not counting labor) wrapped up in this. I simply don't drive it and I'm tired of feeling guilty every time I walk by it for not driving it.
I originally bought this out of California. It is rust free and no body rot anyplace. I built this to be a rock crawler that I could drive to the trail. Everything I did to this was "high end". I didn't cut any corners so you won't be disappointed. Everything has about 4k miles on it. Below is a list of most things I've done to it. Literally, every bolt has been touched or replaced.
You won't be disappointed. You can cruise down the highway at 70 mph with no problem. Brakes work perfectly and the power steering you can use with one finger. The only thing left it could use is a paint job. Reach out to me via email and I'll take any pictures you want and answer any questions you might have. Also, if you arrange for a shipper, I'll what ever you need to get it on their truck.
Here's most of what I've done:
New ignition switch, lock cylinders, headlight switch, dimmer switch, turn signal switch
Radiator professionally cleaned and rebuilt, new radiator hoses, heater hoses, and radiator brackets
Door hinges rebuilt
New Centech body harness and ignition switch harness
New NV4500 (5-speed manual) from Advanced Adapters
Atlas II transfercase from Advance Adapters
Centerforce II clutch
New high angle drive shafts (front and rear)
IDIDIT tilt steering column and Grant steering wheel
Flaming River steering column joints
West Coast Broncos power steering kit
Rebuilt D44 front axles with new seals, bearings, Warn hub locks, braided brake lines, F-150 tie rod conversion, new bumpstops, new bushings, new trackbar, heavy duty D44 axles, F-150 heavy duty knuckles/spindles, new ball joints, and new rotors/calipers/pads
Rebuilt Ford 9” rear axles. New wheel cylinders/brake shoes/drums, braided steel brake lines, new axle seals/bearings and pinion seals/gaskets.
BC Broncos power brake kit with new vacuum assist and master cylinder. Also, new brake lines and adjustable proportioning valve.
1993 Mustang GT 5.0 transplant. Bored .030” over. Ported and polished. Rebuilt by Dave Hiatte Machine Shop in Clovis, CA.
New 3G high output alternator
New plugs, wires, and rebuilt distributor
Wild Horses titanium shorty headers
New accelerator cable, speedometer cable, and VSS sensor (Wild Horses)
New O2 sensors, thermostat, and water pump
New engine wiring harness
Rebuilt heater box with all new gaskets, new high volume blower motor/cage, and heater core
3.5” suspension lift and 2” body lift from BC Broncos. Heavy duty shackles with greasable shackle bolts, heavy duty front shock mounts, heavy duty u-bolt kit, track bar riser, new nitrogen filled shocks, all new bushings and body mounts, and CAGE long arms.
Heavy duty custom built rock sliders (.25” steel, full wrap)
Custom rear bumper with swingout spare tire carrier and high-lift jack mount.
Back seat (currently not installed, but as simple as a few bolts)
Tuffy lockable metal center console with radio
new three point front seat belts
Bikini top
Too many other new installed to list
Boxes of extra parts….