428 R Code Roller with engine and parts

1969 Ford Mustang Description

I purchased car as a project was a roller when bought. Since have collected full quarters, 428 Engine with low hours, top loader 31 spline SCJ, full floor pan built by thoroughbred mustang in Ohio . All glass is with the car, seats, console, rear spoiler, ps cooler, rear valance, cross member, Hurst shifter, Mach 1 roof emblems, Buck tag,door and dash tag in tact. Quarterinterior trim and headliner are there . This car is not for weak at heart. There is a lot of rust, will need parts to complete. The motor and transmission are out of the car. Will need to be trailered . Will need entire floor pan provided with the car. Payment will be local cash or certified check on a national bank. Check must clear before the car is released. Would advise the buyer to view in person. Has the Factory wheels on the vehicle. Can furnish more pictures . Tach dash is in place with wiring, pedals are there . Car came with PS and PB, however the tilt away column was replaced with a standard column. The car was from Kentucky when I purchased. Was inspected by NCDMV.

On Apr-20-17 at 15:43:35 PDT, seller added the following information:

The motor was built and broken 30 over Lemans rods and had a two for set up on it and had very little time, probably four hours on it. Elderbrock rpm intake in on brand-new set a heads everything on top of the othe, interceptor block with cobra jet Lemans rods and crank I have changed the cam and I have cam specs and put the new Mallory distributor with it and those have not been run but those were to the cam that I changed it over to the new aluminum Elderbrock water pump it has an unknown 770 Holly to pump on it and has Harland Sharp roller rockers.