2004 Mustang Mach 1 Built Supercharged Anniversary Edition

2004 Ford Mustang Mach 1 Description

This is a 2004 mustang mach 1, it has 113,500 miles on the body. Almost everything has been replaced on this car and they have roughly 40,000 miles or less.
The body is not 100% showroom clean if that is what you are looking for. The hood has some sun fading and maybe 3 small door dings. The driver seat bolster ripped open so new upholstery will be needed which you can get at late model. I am sure you or someone else can find more issue with the car but remember it is a 2004 that was not garaged its whole life, it was driven.
I will list everything below of what is done to the car. Almost every single part put on this car has paperwork to back it up, i have a folder jam packed of paperwork.
Car will need to be tune again due to head work and a change in boost.
15 psi the car made 604rwhp on pump gas
MOTOR
Forged 4.6 .20 over aluminum block (40,000 miles)
Diamond pistons, eagle rods and cobra crank
Arp 2000 main an rod bolts
Arp head studs
New heads done by cylinder head exchange
Stage 2 comp cams
Ford racing billet timing set
Procharger D1 with upgraded inner cooler(15psi and 18psi pulley)
8 rib setup
Innovators west harmonic balancer
Thump rrr tensioner
Edelbrock high volume water pump
Melling oil pump
On3 performance T-stat coolant mod
Mmr head cooling mod
Diablo mafia
Sct maf
FUEL
Dual gt40 fuel pumps
Kenne bell boost a pump
Aeromotive fuel rails
60lb injectors
3/8 fuel line from tank to rails
Kenne Bell boost a pump
Aem wideband, interceptor and boost gauge

TRANSMISSION
T56 6 speed with 26 spline input shaft
Tri-ax short throw
Spec stage 3 clutch
Fidanza flywheel
Aluminium drvieshaft
Driveshaft safety loop
Adjustable clutch cable
EXHAUST
Kooks longtube headers
X-pipe
Mac catback
Stage 8 locking header bolts

REAREND
373 gears
31 spline axles with longer studs
TA Performance diff cover
SUSPENSION
Tubular K-member with spring perches
Tokico struts, adjustable rear shocks and lowering springs( 1000 miles)
Steeda sway bar
Steeda bumpsteer kit
Subframe connectors
Caster/camber plates
Adjustable rear control arms
New moog wheel bearings and ball joints
WHEELS
Front 19x9.5 255/35/19
Rear 19x11 305/35/19
I am sure i have missed a few things so dont be shy to ask questions or for more pictures of the car.