1957 Chevrolet Bel Air CONVERTIBLE PROJECT

  • Condition: Used
  • Make: Chevrolet
  • Model: Bel Air/150/210
  • Type: CONVERTIBLE
  • Year: 1957
  • Mileage: 128,065
  • VIN: VC57T256174
  • Color: Black
  • Engine size: 283 CID V8
  • Number of cylinders: 8
  • Fuel: Gasoline
  • Drive type: RWD
  • Interior color: Red
  • Options: Convertible
  • Vehicle Title: Clear
  • Interested? Contact seller!

1957 Chevrolet Bel Air/150/210 Description

1957 CHEVY BEL AIR REALCONVERTIBLE, ONYXBLACK /RED/SILVER V8 CARPROJECT, I HAVE OWNED SINCE 1/6/2005,(PURCHASED IN VA)CAME OUT OF CINDER BLOCK BUILDING, CONCRETE FLOOR, IT HAS BEEN IN STEEL BUILDING CONCRETE FLOOR IN FL. SINCE.TITLE ISCLEAR IN MY NAME. 283 V8 ( MID 60S), ORGINAL CAST IRON POWERGLYDE AUTOMATIC TRANSMISSION, AND STOCK REAR END.(DRIVESHAFT OUT OF CAR,PICTURED, WILL BE IN TRUNK)THE MOTOR HAS NOT RUN SINCE I HAVE HAD IT, FREEZE PLUGS REMOVED PREVIOUS OWNER.FIREWALL PLATE STYLE 57 10670TX, BODY NO L33400,TRIM 683 (Red/Silver), PAINT 793 (Onyx Black), ACC BLANK
DOOR JAMB PLATE VC57T 256174
ALL EXTERIOR STAINLESS IS INTACT AND STRAIGH, A FEW MINOR DINGS ON A FEW PIECES.
THE BODY FLOOR PANHAS HAD METAL PATCH PANELS INSTALLED PRIMED ON TOP, BOTH SIDES OF FLOOR,INNER AND OUTER ROCKERS,LOWER FRONT QUARTERS BOTH SIDES,LOWER REAR QUARTER PASSENGER SIDE,REAR TAILPAN,BRACE, ALL PRIMED OR PAINTED, NO BONDO NO SEAM FILLERAND TOP PART OF TRUNK FLOOR TO CURVE,BOTH CURVES INSIDE AND OUTSIDE.TRUNK HAS FLOOR METALPATCH ON DRIVERS SIDE( UNDERNEATH HAS A WEAK SPOT WITH ABOUT A 6 INCH SQUARE HOLE THAT WASNOT CUT OU, ( NEW METAL PUT ON TOP BACK IN THE DAY,GAS TANK PROBABLY WAS IN CAR)ALL BODY MOUNTS AND HARDWARE REPLACED WITH NEW PARTS. CONVERTIBLE BODY DRAIN FOR CONVETIBLE TOP HAS BEEN REPAIRED POORLY,PICTUED (THEY ARE NOW MAKING THIS PART IN 3 PCS OFFERED ON EBAY)FRONT FENDERS HAVE PATCH PANELS LOWER BOTTOM,DRIVERS FENDER HAS METAL REPAIR AROUND HEADLIGHT. THE HOOD AND DECK LID BOTH SOLI, AS AREBOTH DOORS. THE ONLY RUST I HAVE FOUND ON CAR IS TRUNK FLOOR UNDER METAL PATCH, GAS TANK AREA DRIVERS SIDE ABOUT6 INCH SQUARE. AND FRONT OUTSIDE AREA OF FLOOR BEHIND INNER FRONTFENDERS BOTH SIDES A DOUBLE PANEL ABOUT A 4 TO 5 INCH SQUARE ON BOTH OUTSIDENEXT TO FIREWALL PICTURED, AND2 SMALL AREAS ON THE TOP FRONT METALHEADER (ABOUT 1 INCH BY 2 INCHES ON BOTH )PICTURED
ALL CONVERTIBLE PARTS INTACT EXCEPT POWERTOP PUMP AND RAMS WHICH AREIN BOX AS PICTURED ALL STAINLESS ON CAR, MISSING POWER TOP SWITCH (THEY HAVE STARTED MAKING THIS PART) AND CURVED STAINLESS PIECE THATGOES BEHIND REAR VIEW MIRROR, AND MIRROR WILL NEED TO BE PURCHASED.
ALL INTERIOR PANELS AND SEAT SPRINGS ARE MOUNTED AND OR PICTURED(BOTTOM OF BACKCURVED REAR PANELS BOTH NEED METAL REPAIR AT BOTTOM OF PANEL APRX3 INCHES. FRONT SEAT SIDE COVER HAS SOME METAL THAT NEEDS REPAIR ON PASSENGER SIDE.( AN EXTRA ONE FOR REPAIR PANELS IS INCLUDED AND PICTURED) FRONT DOOR PANELS AND BACKPANELSWITH STAINLESS,ARE OFF CARPICTURED, AND IN TRUNK,FRONT ARM REST METAL PICTURED AND WILL BE IN TRUNK IN BOX
SIDE GLASS IS OUT AND PACKED IN A BOX 4 FRONTS, 2 REARS AND 2 VENTS(PICTURED AND WILL BE IN BOX IN TRUNK), REMOVED FOR PICTURES, BOTH REAR WINDOW GEAR ARMS OUT AND PICTURED(IN BOX AND IN TRUNK).DRIVERS DOOR HAS DOOR GLASS GEAR AND VENT GLASS GEAR, PASSENGER DOORHAS NEITHER.
BUMPERS,HEADLIGHT RIMS TAILIGHT HOUSINGS,HOOD SPEARS,GOLDITEMS, MESH IN GRILLEARE DRIVER QUALITY, THE GRILLE CENTER BAR IS SHOWQUALITY WITH A GOODPOLISH.
ALL 5 WHEELS ORIGINAL WITHTABS FOR ORIGINAL 4HUBCAPS, JACK IS IN TRUNKNEW REPO
ONE OF FRAME MOUNTS ON PASSENGER SIDE IS BENT AND NEEDS TO BE REPAIRED AS PICTUREDRADIATOR IS 57 BUT ORGINALLY A 6 CYLINDER MOUNTED IN V8 POSITION,NEW BATTERY TRAY INSTALLEDAIR DUCTS NOT MOUNTED, IN BOX IN TRUNK, AS PICTUREDBOTH INNER FRONT FENDERS HAVE HAD METAL REPAIR AND ARE SOLID
DOOR,TRUNK AND EXTRA IGNITION SWITCH ALL USE ONE KE, 2 KEYS INCLUDED AND EXTRA IGNITION SWITCH IN GLOVE BOX WITH RADIO BESELS AND KNOBS AND KEYS,DASH ITEMS COMPLETE AS PICTURED
CONVERTIBLE TOP FRAMEALL INTACT AS PICTURED, FRONT METAL CURVED HEADERPIECE THAT GOES AGAINST WINDSHIELDNEEDS2 SMALL AREAS REPAIRED ABOUT 3 X 1INCHES LONG ON EACH SIDEAS PICTURED
THE ONLY BONDO I HAVE FOUND ON CAR IS A SKIM ON TRUNK SIDE WALLS AS PICTURED BOTH SIDES (OLD METALREPAIR IN THIS AREA ONBOTH SIDES AS PICTURED)NO SEAM FILLER ONWELDS ON FLOOR, TOP OR BOTTOM, NO BONDO ON QUARTERS, AND ROCKERS, TAILPAN AND FENDERREPAIRS.......
THE CAR HAS NO BRAKES,AND DOES NOT RUN, ALL BRAKE AND GAS LINES NEED TO BE REPLACED, GAS TANK AND STRAPS ARE GOOD DRIVER QUALITY AND TANK IS DRY AND DOES NOT LEAK, CAR ROLL, HEAVY
EXCELLENT SOLIDPROJECT WITH A LOT OF WORK ALREADY DONE, MISSING VERY FEW ITEMS, SELLING BECAUSE I HAVETOO MANY PROJECTS
CAR AND TITLE WILL NOT BE RELEASED UNTIL I HAVE CASH IN HAND.BANK WIRE TRANSFER ACCEPTABLE.(USUALLY TAKES UP TO 4 DAYS)
500.00 DEPOSIT THRU PAY PAL.DUE END OF AUCTION, CAR MUST BE PAID FOR AND PICKED UP7 DAYS..........
CALL PAUL AT 904-742-6449 EASTERN TIME ZONE, FOR MORE PICTURES OR QUESTIONS