1983 Toyota FJ60 Land Cruiser Lifted 4x4 Running Project Extra Body Parts NR

1983 Toyota Land Cruiser Description

This is a 1983 Toyota FJ60 Land Cruiser that has been lifted. I have very little knowledge of this truck as I took it in on a trade it always starts if you pump the pedal a few times and runs pretty well. It carries good oil pressure and doesn't get hot. It started today after sitting for several months and it's 18 degrees outside. It is a manual transmission and runs and drives. The motor is a 6 cylinder with a header on it. It appears to burn some oil as I can smell it when I let it sit and idle. The transmission seems to work fine and the 4wd works as well. The power steering pump is missing the drive pulley so I would assume it needs a new pump. It was driven 40 miles to me but I would say it would need to be hauled as the previous owner stated it had a pretty good shake over 40 miles an hour. I am sure the over sized tires and the lack of power steering didn't help. The body is mostly in black primer, there are several body panels included that are in the truck it looks as if there are 3 doors as well as some other pieces. Someone cut the outer rocker panel off the passenger side to replace it but it looks to need both the inner and outer rocker panels. The rear body mount has been replaced but they didn't finish the edges yet as shown in the pictures. It does have rust but not as bad as a lot of these I have seen, the frame looks to be sound. The interior is pretty basic as can be seen in the pictures. Look at the pictures closely as they are the best description of the body. This would make a nice restoration project or mud toy. THE TIRES AND RIMS DO NOT GO WITH THE TRUCK it will have other tires on it as they are for another truck that I have. There is a 200.00 deposit required within 24 hours of the end of the auction and the remainder is to be paid within 7 days. I have a clean title in hand to the truck. The buyer is responsible for all costs associated with pickup or delivery of the Toyota. This is for local pickup only in Oxford Junction, Iowa 52323 or I can have it delivered for 1.00 per loaded mile from Oxford Junction, Iowa to your location with the mileage to be determined by mapquest or I can assist you or your shipper load the machine for transport. I do have a forklift on site as well. If shipping is needed than the full purchase price plus the deliver fee must be paid for prior to delivery. Please do not bid if you have no intentions of following through as this is a no reserve auction and again THE TIRES and RIMS ARE NOT INCLUDED IN THE SALE. Thanks